|
1951 Chevy Accessories Installation Manual |
|||
|
986403 CIGARETTE LIGHTER AND LIGHT |
|||
|
|
|||
|
Procedure
for Installation of
Cigarette
Lighter and Light
on All
Model Trucks.
1. Remove and discard dummy button or
present lighter.
2. Remove lamp socket from clamping shell
and clamping shell from
lighter.
3. Insert lighter in hole and reassemble clamp
shell and lamp
socket.
4. Rotate clamp shell to position such that
unit causes no
interference.
5. Attach lamp socket wire to tail lamp
terminal on the light
switch, (see figure 135).
6. Attach cigarette lighter wire to terminal
on back of light switch, (see figure 135).
Approximate Flat Rate Time .2 of
an hour. |
 |
||
|
Figure 137
1.
Recommended dimension from bottom of moulding to upper edge of mirror base is
7/8 of an inch as shown in
figure 138. |
|||
|
|
|||
|
986530 REAR VIEW MIRROR - PRISMATIC
Procedure
for Installation of
Rear View
Mirror (Inside) on All Model Passenger Cars. |
 |
||
 |
|||
|
Figure 138
2. Loosen
screw "B," set base at angle of door edge and tighten securely as shown in
figure 139. |
|||
|
Figure 136
1. Remove equipment rear view mirror from
windshield divider by
loosening jam nut and unscrewing mirror from windshield
divider.
2. Install PRISMATIC rear view mirror on
windshield divider and tighten
jam nut.
3. Rotate mirror on ball so that name tab on
the mirror is at the
bottom.
Approximate Flat Rate Time .1
of an hour. |
|||
 |
|||
|
986305 OUTSIDE REAR VIEW MIRROR
Procedure
for Installation of
Outside
Rear View Mirror
on All
Model Passenger Cars. |
|||
|
Figure 139 |
|||
|
|
|||
|
58 |
|||
|
|
|||
| « PREVIOUS PAGE | CONTENTS PAGE | NEXT PAGE » |
|
|