|
1951 Chevy Accessories Installation Manual |
|||
|
1. Line up template on left hood half and
center punch as indicated
on template, turn template
over and line up on right hood half and center punch as indicated on template.
Drill two half-inch holes in
each hood half,
2. Drill one 7/16 inch hole in hood top
moulding, using existing
hole in hood panel as template. Enlarge hole in hood top moulding
only, to half
inch.
Approximate Flat Rate
Time .2 of an hour.
986162 HOOD ORNAMENT - TRUCK Procedure
for Installation of Hood Ornament on
4000-6000 Model Trucks.
1. Use
template furnished with ornament and proceed as outlined for commercial
ornament
986161.
Approximate Flat Rate
Time .2 of an hour. 986519 PANEL REAR
WHEEL
Procedure
for Installing Rear Wheel Panel on All
Model Passenger Cars. |
 |
||
|
Figure 152
1. Clean all dirt and insulating material from
metal surfaces at places where
brackets attach.
2. Install panel front and rear retainers with
lockwasher at existing bolt.
(See figure 150.)
3. Insert cover into fender opening and with
top of cover and front edge of
cover in line with surface of
fender, scribe two holes on fender flange through the two holes on the front
of the cover flange. With the top and rear edge of the cover in line with the surface of
the fender scribe two holes on fender flange through the two holes in the rear flange
of |
|||
|
|
|||
 |
|||
|
|
|||
|
Figure 150 |
|||
|
|
|||
 |
|||
|
|
|||
|
Figure 151 63 |
|||
|
|
|||
| « PREVIOUS PAGE | CONTENTS PAGE | NEXT PAGE » |
|
|