|
1951 Chevy Accessories Installation Manual |
|||
|
Procedure
for Installing
Glove
Compartment Light
on All
Model Trucks - 986489
1. Install bracket in upper left-hand corner
using holes and screws
provided, and assemble switch
to bracket.
2. Clip wire to lower flange of instrument
panel using three clips
furnished in package. (See
figure 126.)
3. Connect wire to dome lamp terminal on light
switch. (See figure
126.)
Approximate Flat Rate Time .2
of an hour. |
2. Attach wiring
clips in slots in under-side of panel
back of rear seat as shown in figure 128. Insert wire in
clips.
3. Strip half inch of insulation from tail
lamp wire in wiring harness
(natural with black tracer) at
point "A" splice, solder and tape compartment lamp wire at this point. Light
switch must be on to have trunk light operate. Raising trunk lid automatically
turns "on" light. Lowering lid
automatically turns "off" light.
Approximate Flat Rate Time .1
of an hour. |
||
|
|
|||
 |
|||
|
|
|||
|
Figure
126 |
|||
|
|
|||
|
986238 LUGGAGE COMPARTMENT LAMP
Procedure
for Installation of
Luggage Compartment
Lamp
on All
Model Passenger Cars. |
 |
||
 |
|||
|
Figure 127
1. Remove
cover from luggage compartment lamp,
insert wire through hole provided in inner panel. Place wire between inner and
outer panels and out through grommet as shown in figure 128. Attach lamp using the
two self-tapping screws furnished. Insert grommet and replace lamp
cover. |
|||
|
Figure 128
986250 UNDERHOOD LAMP
Procedure
for Installation of Underhood Lamp on
All Model Passenger Cars and Trucks.
PASSENGER CAR |
|||
|
|
|||
|
54 |
|||
|
|
|||
| « PREVIOUS PAGE | CONTENTS PAGE | NEXT PAGE » |
|
|