|
1951 Chevy Accessories Installation Manual |
|||
|
from
which the regular parts were removed. (See figure 109.)
Tighten
attaching screw securely. Approximate
Flat Rate Time .1 of an hour. 986523 DUAL FOG LAMPS
Procedure
for Installation of Dual Fog Lamps on
All Model Passenger Cars. |
outer
clamp should be located 7/8 of an inch
from the bend in the bumper support bar as shown in figure 113. Insert
lamp mounting brackets thru
the inner and outer clamps
until brackets touch filler panel. Mark circle around brackets on filler panel,
then remove brackets and
clamps. Locate center of circles
and drill 1/4 inch holes in
filler panel. With 1-1/2 inch hole saw use 1/4 inch holes for guide in cutting the
1-1/2 inch holes in filler
panel.
2. Reassemble the
inner and outer clamps to the bumper
support bars loosely and insert lamp mounting brackets from top
side of filler panel into the inner
and outer clamps. Adjust lamp
mounting brackets so as to have 2-17/32 inches clearance from
bumper guards as shown in figure 112,
insert rubber grommet in filler panel and tighten clamps securely.
3. Assemble fog lamps to brackets loosely,
using the washers and nut
as shown in figure 112.
4. Place right-hand fog lamp wire thru clip on
fender skirt and around
radiator tie bar to left-hand
side of car as shown in figure 113.
5. Place left-hand fog lamp wire thru clip on
fender skirt and grommet in
front fender skirt as shown in figure 113, left-hand fog lamp wire to follow the car wiring harness
thru grommet in dash into
passenger compartment. |
||
 |
|||
|
Figure 111
1. To
locate 1-1/2 inch holes in the filler panel, assemble inner and outer clamps to the
bumper support bars as shown
in figure 112, |
|||
|
|
|||
 |
|||
|
|
|||
|
Figure 112 |
|||
|
|
|||
|
44 |
|||
|
|
|||
| « PREVIOUS PAGE | CONTENTS PAGE | NEXT PAGE » |
|
|