|
1951 Chevy Accessories Installation Manual |
|||
|
2. Line up seat cover to contour of cushion,
and hog ring front edge as
shown in Figure 35.
3. Pull seat cover down under bottom edge of
side panels and install spring
clips as shown in Figure
34. |
4. Cut back out of seat cover, as
shown in Figure
37. |
||
 |
|||
 |
|||
|
Figure 37
5. Place seat cover over back rest and line up
seams with contour of back
rest and hog ring as shown in
Figure 39.
5a. Place
two 20 inch wires in rear edge of front seat cover and fasten with "S" hooks
as outlined on page 10, figure
22.
6. Place seat cover on seat cushion and line
up seams with contour of
cushion and hog ring as shown
in Figure 38. |
|||
|
Figure 35
Approximate Flat Rate
Time 1 hour. SEAT
COVERS
Exposabilt
Installation of
Front
Seat Only (Fiber - Plastic -
Rayon)
FOUR-DOOR FRONT SEAT
1. Remove seat adjuster knob and side panels
from seat
assembly.
2. Remove four cap screws from each side of
seat assembly which hold seat
to floor pan of body and
remove front seat assembly from
car.
3. Remove the three sheet metal screws
located at the bottom rear
edge of back rest as shown in
Figure 36. Remove back panel by pushing down on back
panel. |
|||
 |
|||
|
Figure 38 |
|||
|
|
|||
 |
|||
|
|
|||
|
Figure 36 |
|||
|
|
|||
|
14 |
|||
|
|
|||
| « PREVIOUS PAGE | CONTENTS PAGE | NEXT PAGE » |
|
|