|
1951 Chevy Accessories Installation Manual |
|||
|
PASSENGER CAR |
|||
|
|
|||
|
Locate four mounting holes in
dash or right-hand engine side of
dash and drill holes as shown in figure 10. Install overflow
condenser unit with pipes at bottom, using screws
furnished. |
 |
||
 |
|||
|
Figure 12 |
|||
|
TRUCK
Locate
four mounting holes on right-hand engine side of dash and drill holes as
shown in Figure 13. Install overflow
condenser unit with pipes at
bottom, using screws furnished. |
|||
 |
|||
|
Figure 10
Connect
twenty inch length of small diameter overflow hose to center pipe on
bottom of condenser
unit.
Cut
radiator overflow pipe as shown in figure 11 and connect six foot length of large
diameter hose to radiator
overflow pipe. Pass hose around battery, then between air duct and skirt and attach to remaining pipe
on bottom of condenser unit as
shown in figure 10. |
|||
|
|
|||
 |
Figure 13 |
||
|
2. Connect twenty inch length of small
diameter hose to center
pipe on condenser unit.
3. Attach six foot length of large diameter
hose to bottom of radiator
overflow pipe being sure pipe
is round. Lay hose on lower edge of side member and attach to remaining pipe
on condenser
unit.
NOTE: Be
sure that radiator cap and all other
cooling system connections are tight. BE SURE THAT HOSE IS NOT
KINKED. |
|||
|
Figure 11
4. If
radiator pressure cap is used remove and insert upper gasket in cap as shown in
figure
12. |
|||
|
Approximate Flat Rate Time .2 of
an hour. |
|||
|
|
|||
|
8 |
|||
|
|
|||
| « PREVIOUS PAGE | CONTENTS PAGE | NEXT PAGE » |
|
|